Genie GS-1930 Operator's Manual page 41

Sixth Edition • Ninth Printing
Use this function test procedure if the decal on
your platform controls has these buttons.
Test the Outrigger Function (GS-3232)
98 Raise the platform.
Result: The platform should raise to 22 ft /
6.7 m and stop.
99 Fully lower the platform.
100 Press the outrigger function button.
On the LCD screen, a circle below
the outrigger function symbol will
turn on.
If the control handle is not moved within seven
seconds of pushing the outrigger function button,
the circle below the outrigger function symbol will
turn off and outrigger function will not operate.
Press the outrigger function button again.
101 Press and hold the function enable switch on
the control handle.
102 Move the control handle in the direction
indicated by the yellow arrow.
Result: The outriggers should extend. The
individual outrigger indicator lights will flash
green as the corresponding outrigger extends.
Part No. T107026
103 Continue holding the control handle in the
direction indicated by the yellow arrow until all
outrigger indicator lights turn solid green and a
long beep is heard from the platform controls
alarm. The machine is now level. At this point,
the drive and steer functions are disabled.
Note: If the control handle or foot switch (if
equipped) are released too soon during extension,
the outrigger indicator lights will continue to flash
green, indicating the outriggers are not contacting
the ground.
Note: If the control handle or foot switch (if
equipped) are released too soon after the
outriggers have contacted the ground, a long beep
will not be heard at the platform controls and the
outrigger indicator lights will be solid green. If a
long beep is not heard and the outrigger indicator
lights are solid green, this condition may indicate
the outriggers are not fully deployed or the
machine is not level.
104 Press the drive function button.
105 Press and hold the function enable switch on
the control handle.
106 Slowly move the control handle in the direction
indicated by the blue arrow, then in the
direction indicated by the yellow arrow.
Result: The machine should not move in the
directions indicated by the blue and yellow
arrows.
GS-30 • GS-32 • GS-46 • GS-47
Operator's Manual
Inspections
39