Ssb Out Level; Ssb Ptt Select; Ssb Tx Bpf; Apf Width - Yaesu FT-891 Advance Manual

Menu Mode

11-06 SSB OUT LEVEL

Function: Sets the level of the SSB receiving signal output from the RTTY/DATA jack.
Available Values: 0 - 100
Default: 50
11-07 SSB BFO
Function: Sets the SSB carrier oscillator injection side for the SSB mode.
Available Values: USB/LSB/AUTO
Default: AUTO
Description: USB: Injects the SSB carrier oscillator on the USB side.
LSB:
AUTO: Injects the SSB carrier oscillator on the LSB side while operating

11-08 SSB PTT SELECT

Function: Sets the PTT transmit control for the SSB signal.
Available Values: DAKY/RTS/DTR
Default: DAKY
Description: Selects the PTT transmit control method for the SSB signal.
DAKY: Controls the transmit signal from the RTTY/DATA jack ( pin 3 ) on the
DTR:
RTS:

11-09 SSB TX BPF

Function: Sets the frequency characteristics of the DSP band-pass filter for transmitting
in SSB mode.
Available Values: 100-3000/100-2900/200-2800/300-2700/400-2600
Default: 300-2700 Hz
Description: Selects the frequency characteristics setting of the DSP band-pass filter
when transmitting in SSB mode.

12-01 APF WIDTH

Function: Sets the bandwidth of the audio peak filter.
Available Values: NARROW/MEDIUM/WIDE
Default: MEDIUM
Description: In CW mode the APF peak center frequency is set according to the CW
PITCH frequency and the chosen APF bandwidth value. In order to listen
to the desired signal comfortably, select one of the three bandwidths of the
peak filter.
Injects the SSB carrier oscillator on the LSB side.
on the 7 MHz band and below, and the USB side while operating
on the 10 MHz band and up.
rear panel.
Controls the transmit signal from the USB virtual COM/DTR ports.
Controls the transmit signal from the USB virtual COM/RTS ports.
91 FT-891 Advance Manual