Yaesu FT-891 Advance Manual page 74

Menu Mode
02-03 DIMMER LCD
Function: Sets the LCD display brightness level.
Available Values: 1 - 15
Default: 8
Description: Sets the brightness level of the LCD display. The effect of the changes may
be observed as the brightness level is adjusted. The higher the setting, the
brighter the illumination becomes.
02-04 DIMMER TX/BUSY
Function: Sets the TX/BUSY Indicator brightness level.
Available Values: 1 - 15
Default: 8
Description: Sets the brightness level of the TX/BUSY Indicator. The effect of the
changes may be observed as the brightness level is adjusted. The higher
the setting, the brighter the illumination becomes.
02-05 PEAK HOLD
Function: Sets the meter peak hold.
Available Values: OFF/0.5/1.0/2.0 ( sec )
Default: OFF
Description: Sets the time length the maximum value reading is shown on the meter
( peak hold ) .
OFF:
0.5/1.0/2.0: Holds the maximum value for the time length that is set.
02-06 ZIN LED
Function: Enables/Disables the zero in indicator ( TX/BUSY indicator ) .
Available Values: ENABLE/DISABLE
Default: DISABLE
02-07 POP-UP MENU
Function: Set the display position of the pop-up screen.
Available Values: UPPER/LOWER
Default: LOWER
03-01 DVS RX OUT LEVE
Function: Sets the voice memory monitoring level.
Available Values: 0 - 100
Default: 50
Description: You can adjust the voice memory monitoring level. The higher the setting,
the higher the out-put level becomes.
Disables the peak hold function.
74 FT-891 Advance Manual