Installation Guide
1 Introduction
The AP-7522 external antenna and internal antenna Access Point's are mid-tier Access
Point's with a relatively small footprint which supports functionality for dependable and
efficient network performance.The AP-7522 is a 2x2:2 802.11ac Access Point utilizing one
2.4 GHz 802.11n radio and one 5 GHz 802.11ac radio. The Access Point housing is
Plenum-rated (UL2043).
The Access Point's unique WiNG 5 software enables the Access Point to function as either a
Standalone Access Point, an Adaptive Access Point, or a Virtual Controller.
If new to Access Point technology, refer to the WiNG Access Point System Reference Guide
to familiarize yourself with Access Point technology and the feature set supported by the
WiNG operating system. The guide is available at www.zebra.com/support.
This document is written for the qualified network device installer.
1.1
Document Conventions
The following graphical alerts are used in this document to indicate notable situations:
NOTE
CAUTION
WARNING!
1.2
Warnings
•
Read all installation instructions and site survey reports, and verify correct equipment
installation before connecting the AP-7522 Access Point.
•
Remove jewelry and watches before installing this equipment.
•
Verify any device connected to this unit is properly wired and grounded.
•
Verify there is adequate ventilation around the device, and that ambient temperatures
meet equipment operation specifications.
Tips, hints, or special requirements that you should take
note of.
Care is required. Disregarding a caution can result in
data loss or equipment malfunction.
Indicates a condition or procedure that could result in
personal injury or equipment damage.
5