1
Extreme Networks AP-8432 internal antenna Access Point's are high-tier Access Points for
dependable and efficient network performance.
The Access Point's unique WiNG 5 software enables the Access Point to function as either a
Standalone Access Point, an Adaptive Access Point or a Virtual Controller.
If new to Access Point technology, refer to the WiNG Access Point System Reference Guide
to familiarize yourself with Access Point technology and the feature set supported by the
WiNG operating system. The guide is available at
This document is written for the qualified network device installer.
Document Conventions
The following graphical alerts are used in this document to indicate notable situations:
NOTE
Tips, hints, or special requirements that you should take note of.
CAUTION
Care is required. Disregarding a caution can result in data loss or equipment
malfunction.
Warnings
•
Read all installation instructions and site survey reports, and verify correct
equipment installation before connecting the AP-8432 Access Point.
•
Remove jewelry and watches before installing this equipment.
•
Verify any device connected to this unit is properly wired and grounded.
•
Verify there is adequate ventilation around the device, and that ambient
temperatures meet equipment operation specifications.
Site Preparation
•
Consult your site survey and network analysis reports to determine specific
equipment placement, power drops, and so on.
•
Assign installation responsibility to the appropriate personnel.
•
Identify and document where all installed components are located.
•
Ensure adequate, dust-free ventilation to all installed equipment.
•
Identify and prepare Ethernet and console port connections.
AP-8432 Installation Guide
Introduction
www.extremenetworks.com/support/.
5