Installation Method; Name And Operation Of The Button On The Wired Controller; Mode Button; Timer On Button - Westinghouse WPAXH-060CA4 Service Manual

WESTINGHOUSE PACKAGE A/C MANUAL R-410A : 220V: 60Hz

5. Installation method

When a wired controller is needed, a small 5-way terminal should be added. Fix an infrared emitter with gum
water near the receiver on the switch board. Connect its anode and cathode to A and B, and +5V, GND, RUN
to C, D, E on the switch board.

6. Name and operation of the button on the wired controller

① Mode button:

When press this button, the operation mode change as the following sequence:
Remark: For the cooling only model, the heating mode is skipped.

② Timer on button :

Press this button, timer on function is active. Then every press, the time increase 0.5h, after 10h, 1h increase
after each press. If cancel this Function, just set it to "0.0".
③ Timer off button:
Press this button, timer off function is active. Then every press, the time increase 0.5h, after 10h, per 1h
increase after each press. If cancel this function, just set it to "0.0".
④ Follow me button:
When under cool, heat and auto mode, press this button, follow me function is active. Press again, this
function is ineffective.
⑤ Electrical heater button :
If press this button in heat mode, electrical heater function become ineffective.
100