Applying Color Identification Labels - Siemens Simantic ET200SP System Manual

5.15.3

Applying color identification labels

Requirements
The BaseUnits must not be wired when you apply the color identification labels.
Required tools
3 mm screwdriver (only for removing the color identification labels)
Applying color identification labels
Press color identification labels into the terminal box of the BaseUnit.
Note
To remove the color identification labels, you must first disconnect the wiring on the
BaseUnit and then carefully lever the color identification labels out of the holder using a
screwdriver.
①
②
③
④
⑤
Figure 5-35
Distributed I/O system
System Manual, 12/2016, A5E03576849-AG
Module-specific color identification labels (15 mm) for the process terminals (see I/O module
(http://support.automation.siemens.com/WW/view/en/55679691/133300) Manual)
Color identification labels (15 mm) for the 10 AUX terminals
Color identification labels (15 mm) for the 10 add-on terminals
Color identification labels (20 mm) for the 4 AUX terminals
Color identification labels (20 mm) for the 2 AUX terminals
Applying color identification labels
Wiring
5.15 Labeling ET 200SP
137