Connecting Interfaces For Communication; Connecting Profinet Io To The Cpu/Interface Module Via The Bus Adapter Ba; 2Xrj45 - Siemens Simantic ET200SP System Manual

5.12

Connecting interfaces for communication

Connect the communication interfaces of the ET 200SP distributed I/O system using the
standardized connector or directly. If you want to prepare communication cables yourself,
the interface assignment is specified in the manuals of the corresponding modules. Observe
the mounting instructions for the connectors.
5.12.1

Connecting PROFINET IO to the CPU/interface module via the bus adapter BA

2xRJ45

Introduction
You connect PROFINET IO to the CPU/interface module via the BusAdapter BA 2×RJ45. To
do this, screw the BusAdapter BA 2×RJ45 to the CPU/interface module and insert the
PROFINET connecting cable. You can loop PROFINET through via the integrated 2-port
switch.
Figure 5-12
Required tools
3 to 3.5 mm screwdriver
Required accessories
Please refer to the specifications in the PROFINET Installation Guide
(http://www.profibus.com).
Mounting the bus connector
Mount the PROFINET connector according to the instructions in PROFINET Installation
Guide (http://www.profibus.com).
Distributed I/O system
System Manual, 12/2016, A5E03576849-AG
BA 2×RJ45 BusAdapter
5.12 Connecting interfaces for communication
Wiring
101