Table of Contents
Advertisement
NITRO POWER UNIT
67. Next attach the cowl in place, make sure drive
washer is exposed about 2~3mm from the cowl. Make
marks on the cowl base on the drawing on the paper.
68. Trim away the drew area and trial fit the muffler.
69. Trial fit the muffler, next trim the cowl where might
contact carburetor.
70. Drill Glow Plug ignition hole, needle valve hole and
muffler securing hole for driver.
71. Install the propeller and spinner then secure the
cowl with six 2x8mm wood screws.
72. Install the switch on fuselage, properly connect all
wires. Next wrap the receiver and battery with foam and
secure them in fuselage.
18
73. Cut away the covering at landing gear area.
74. Locate a plywood template, place it on the landing
gear area then draw lines along the edge of the template
on the wing.
75. Slightly cut away the covering of the line you drew.
You may find the laser cut lines on the planking.
RETRACT
76. Use hobby knife and remove the planking along the
laser cut lines.
77. Use hobby knife cut the wing root planking as shown.
At least 2"(5cm) in width for easy install the retract servo.
78. Locate four pieces plywood then CA two pieces
together, next glue this servo mount in place.
19
Advertisement
Table of Contents
