Furuno TZTBB Installation Manual page 16

2. WIRING
Video input
TZTBB can use regular analog video inputs (PAL or NTSC) that connect to the TZTBB
directly or use IP cameras that connect directly to the network HUB. IP cameras can
be seen by all TZTBB connected to the NavNet TZtouch network, unlike analog video
that can be viewed only on the equipment where the source is connected. Additionally
some IP cameras can be controlled from TZTBB.
Analog video
The TZTBB processor unit has two analog video inputs (PAL/NTSC) on 2 mm RCA
type connectors located on the rear of the equipment. For this connection, the follow-
ing cable is necessary (local supply).
• 3C2V (Japan Industrial Standard (JIS), or the equivalent) coaxial cable
(impedance: 75 )
IP camera
IP cameras are network devices that connect directly to a HUB. Up to four IP cameras
can be connected to one NavNet TZtouch network. At this time, only AXIS IP cameras
that support MPEG4 video are functional in the network. For more details, see the op-
erator's manual for the AXIS IP cameras.
DVI-D (external monitor)
A DVI monitor is required for the TZTBB. The plug is DVI-D format and only a DVI-D
monitor with VESA DDC (Display Data Channel) can be connected. The TZTBB uses
the monitor information (EDID) given via DDC to output the video data with the appro-
priate resolution. FURUNO offers two lengths of DVI-D cables, 5 m and 10 m.
Note: When a second monitor is used, use the same aspect ratio and resolutions
monitor as the first monitor. The DVI-OUT1 port should be used in DVI-D connection.
If this port is converted into HDMI, the DVI-OUT2 port may not transmit the picture sig-
nal.
USB port
The TZTBB has six USB Ver. 2.0 ports. The USB port2/3 are used to connect USB
Touch Monitor (compatible with Windows
used to connect to switch box for SDXC card. The USB port5/6 are used to connect
the devices for internal installation.
Audio
Outputs the audio line from the left-hand connector.
2-8
Conductor
2
S = 0.19 mm
φ = 0.5 mm
Insulator
Shield
Vinyl sheath
®
7 HID generic driver) and USB port 1 is