Can Bus/Nmea0183 Data Conversion - Furuno TZTBB Installation Manual

2.2

CAN bus/NMEA0183 Data Conversion

2.2.1 Connection with DRS radar sensor
All DRS radar sensors have one CAN bus port (Terminal Block connector). You can
directly connect FURUNO CAN bus sensors to the DRS radar without having to run
another CAN bus cable up the mast. In this case, each separate CAN bus network (the
DRS CAN bus and the ship CAN bus) will be "Bridged" together via the Ether Network.
Note that the TZTBB and DRS CAN bus ports must not be connected together.
Connection of multiple TZTBBs, no DRS radar sensor
Connect multiple TZTBBs with Ethernet and CAN bus cables.
TZTBB
(MPU-002)
Connection of TZTBB and DRS radar sensor
Connect TZTBB to DRS radar sensor with Ethernet cable.
GPS RECEIVER
GP-330B
(MPU-002)
Ethernet cable
TZTBB
TZTBB
(MPU-002)
CAN bus cable
RADAR SENSOR
DRS2D/4D
DRS4A/6A
DRS12A/25A
POWER SUPPLY UNIT
PSU-012: w/DRS2D/4D/4A/6A/12A
PSU-013: w/DRS25A
: Ethernet cable
: CAN bus cable
2. WIRING
2-9