Events - Night Owl NVR10 SERIES User Manual

Load Default: revert back to the standard reboot schedule.
Save Settings: save reboot settings to a USB flash drive.
Load Settings: load previously saved settings from a USB flash drive.
Shutdown: reboot the NVR.
IPC Upgrade: allows you to upgrade the IPC configurations to the selected
channels by uploading the desired IPC configuration from a USB flash drive. Keep
in mind this should only be done if you have extensive knowledge in this field.

7.6.2 Events

Configure notification settings for other triggered events not related to motion
detection such as disk error, disk full or and/or video loss.
Event Type: choose the type of event you would like to create a notification for.
Disk Full means you will receive a notification if the HDD is full. Disk Error refers
to the status of the HDD and will notify you if it crashes or has become corrupt.
Video Loss is the absence of video due to power loss disconnection.
Enable: turn notifications on or off for the selected Event Type.
Show Message: enable an icon to be displayed in Live View when the selected
Event Type is triggered.
Send Email: allows you to check this box if you would like an alarm to be sent for
the selected event type.
Latch Time: select the amount of recorded video before an event is triggered. You
can select from 10 seconds up to 1 minute.
Send Email: sends an email to notify you an alert has been triggered.
Buzzer: turn an audible buzzer on for a duration of time to alert you when this
Event Type happens. Choose OFF to disable this feature. You can select in
between 10 and 60 seconds.
Chapter 7: Menus and Settings 55