Message List - Oki es7120 Reference Manual

M
ESSAGE LIST
This section describes the messages displayed on the control panel.
MESSAGE
Bad Action
Bad Action Str
Bad BUFSIZE Cmd
Bad COLUMN Cmd
Bad FEntry CMD
Bad FORMLINES
Bad Header Cmd
Bad LINE Cmd
Bad PAGE Cmd
Bad PORT Cmd
Bad Target Str
Bad TEntry CMD
Call Service
Call Service Perform
Maintenance
Cancel Job
Canceling Job
Clock Not Set
Close Duplexer
Close Rear Cover
Close Top Cover
Code FLASH Error
Command Format
Completed
Cover Open
Disk Unformatted
Drive Full Error
Duplex Failure
Engine NV Fail
Exit Jam
CONDITION/REASON/ACTION
Format error.
Missing or bad action defined for job.
Format error on BUFSIZE command.
Format error on COLUMN command.
Unrecognized Form Entry command.
Format error on FORMLINES command.
Unrecognized Header command.
Format error on LINE command.
Format error on PAGE command.
Format error on PORT command.
TARGET string format error.
Unrecognized Target Entry command.
Help message used for service-type errors.
Fuser End of Life: Call service technician to install
maintenance kit (Fuser, Feed Rollers and Transfer
Roller).
Confirmation prompt used when CANCEL is
pressed.
An operator-requested Cancel is in progress.
Real Time Clock has not been initialized.
Recovery message displayed when duplex door is
open.
Recovery message displayed when rear cover is
open.
Recovery message displayed when top cover is
open.
Defective Code Flash - user forced into Firmware
Upgrade.
Bad command format.
Display for the files status.
Recovery action displayed when cover is open.
Error message displayed when unformatted disk is
detected.
The storage device that you are trying to copy to is
full.
Duplex Unit Failure.
Error message displayed for Engine NV Failure. Call
Service.
Paper jam detected.
Troubleshooting > 109