Step Setting - Mitsubishi Electric FR-PU07 Instruction Manual

2.2.2 Step setting

A frequency is continuously varied using the Cursor-keys ▲/▼. You can vary the frequency only while you press the ▲/▼-keys.
Since the frequency varies slowly at first, this setting can be used for fine adjustment.
Example: Changing from 0 Hz setting to 50 Hz setting
Description
Press the PU-key.
The frequency setting screen appears.
Press the Cursor-keys ▲/▼ to enter a
desired value (50.00 Hz). You can set
any value between the maximum fre-
quency (Pr. 1) and minimum frequency
(Pr. 2 ).
Press the WRITE-key.
The 50 Hz setting is complete.
REMARKS
Display
During operation, you can also make the step setting to change the run-
Freq Set
ning frequency. Note that if you operate the
SET 0.00Hz
mode, the inverter does not operate at the frequency when you release
‘
the key and the frequency further increases (or decreases).
0~400Hz
(Since ▲/▼-key is used to vary the preset frequency, the varied fre-
quency will differ from the output frequency.)
Freq Set
SET 0.00Hz
‘ 50.00Hz
0~400Hz
Freq Set
SET 50.00Hz
‘
Completed
FUNCTIONS
▲/▼
-keys in the monitor
2
19