Full Speed Usb Configuration - Metrologic MS2020 Stratos series Service Manual

STRATOS SYSTEM AVAILABLE CONFIGURATION / SET-UP

Full Speed USB Configuration

Initializing Scanner into Full Speed USB mode:
1. With only Stratos Scanner Power on and Host device Power off.
2. Scan 'Enable Full Speed USB Defaults' barcode below. (This will place the Stratos Scanner
in the USB communications setting between itself and the Host device.)
3. Now apply power to Host Device.
©2004 Metrologic Instruments, Inc. All rights reserved
F u ll S p e e d U S B D e fa u lts
65
E n a b le
³ 9 9 9 9 7 0
MS2020 Stratos Service Manual