Integrated Usb Full Speed; Low Speed - Metrologic MS9500 Voyager series Installation And User Manual

I
NSTALLING THE
I USB: F
NTEGRATED
1. Turn off the host system.
2. Connect the 10-pin RJ45 male
connector of the USB cable into the
jack on the scanner. You will hear a
'click' when the connection is made.
3. Connect the other end of the USB
cable to the host USB port.
4. Turn on the host system.
As a default, the MS95x0-38 leaves the factory with USB Keyboard
Emulation Mode eabled.
For information on configuring the MS95x0-38 for USB Serial
Emulation Mode, please refer to the USB section of the MetroSelect
Single-Line Configuration Guide (
Plugging the scanner into a port on the host system does not guarantee
that scanned information will be communicated properly to the host
system. Please refer to the MetroSelect Single-Line Configuration
Guide or MetroSet2's help files for instructions on changing the
scanner's factory default configuration. The scanner and host system
must use the same communication protocols.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must
meet the requirements for SELV (Safety Extra Low Voltage) according to EN 60950.
To maintain compliance with standard CSA C22.2 No. 950/UL 1950 and norm EN 60950, the
power source should meet applicable performance requirements for a limited power source.
8
S T
CANNER O
S MS9520-40
ULL PEED
L S MS9520-38
OW PEED
T H S
HE OST YSTEM
AND
AND
00-02544).
MLPN
MS9540-40
MS9540-38
Figure 5.