Rs232 Configuration - Metrologic MS2020 Stratos series Service Manual

STRATOS SYSTEM AVAILABLE CONFIGURATION / SET-UP

RS232 Configuration

Initializing Scanner into RS-232 Communications Mode:
1. With only Stratos Scanner Power on and Host device Power off, scan Recall Defaults
barcode.
2. After scanner defaults is settings and beeps, then scan Enable RS-232 mode. (This will
place the Stratos Scanner in the RS-232 communications setting between itself and the
Host device.)
3.
Now apply power to Host Device.
Recall Defaults
st
Scan 1
9 9 9 9
©2004 Metrologic Instruments, Inc. All rights reserved
9 8
64
Enable RS-232
4 1 5 5 5 4
MS2020 Stratos Service Manual