Auxiliary Sp And Pv Pre-Plot; Setpoint Programmer Operate - Honeywell 900 User Manual

3. Advance – Advance is an action that can be initiated manually from the SPP user interface or from the
control strategy via a digital input to the SPP function block. The Setpoint Programmer must be in the
Hold state to accept an Advance input. Advance is a single shot action and each rising edge of the
input will cause the program to advance one segment through its sequence. Advance may be used
through multiple actions to completely cycle through a program and restart at a previous segment.
Following an Advance action, the Process Variable plot starts plotting from the beginning of the segment
determined by the Advance action.

Auxiliary SP and PV Pre-plot

1. The actions and responses of the Auxiliary PV4 and the Auxiliary SP pre-plot graph will be the same
as the PV1 value on the SPP profile pre-plot graph for the special cases above.
2. The default colors of the Auxiliary SP Pre-plot and PV are the same as the Setpoint Profile colors.
(Yellow and aqua).

Setpoint programmer Operate

This widget may be accessed either from a Home display button or by jumping from the Setpoint
Programmer Overview widget.
It shows the details of the profile currently running in the Setpoint Programmer. You can also load a
different profile from memory into the Setpoint Programmer, edit the current profile, and save the edited
profile to any slot (profile number) in memory.
Revision 9
May 2014
900 Control Station User Guide
Setpoint Programmers
Setpoint programmer Operate
125