View/Edit Profile - Honeywell 900 User Manual

View/Edit profile

This display lets you view or edit parameters of the currently working profile. Edits affect only the
currently working program (not the profile in memory) and are lost if the profile is Reset, unless you Save
Profile to Memory.
ATTENTION
Program must be in READY state to be edited.
Item
View/Edit Segments Button
Profile number
Profile Name
Profile Description
Ramp Type
Time Units
Primary Output Label
Primary Engineering Units
Guaranteed Hold High Limit
Guaranteed Hold Low Limit
Revision 9
May 2014
Accesses View/Edit Profile Segments (page 131) where you can edit each
segment.
Memory location of the profile that is being run by the Setpoint
Programmer.
Name of the selected profile.
Description of the profile.
TIME: Each ramp segment's time is the TIME allotted to the profile's
output to reach the next soak segment's value in hours or minutes.
OR
RATE: Each ramp segment's time specifies the RATE at which that
profile's output will reach the next soak segment, where the rate is
specified in EU/hour or EU/minute.
Make this selection before entering any Ramp during Profile Edit.
NOTE: When Ramp unit is configured for TIME, entering "0" will imply an
immediate step change in setpoint to the next soak.
This selection assigns the time units (hours or minutes) for the ramp type
selected.
For Time ramp type: Time = Hours or Minutes
For Rate ramp type: Rate = EU/Hour or EU/Minutes
Label associated with the PV.
Engineering Units of the PV
The profile will hold if a PV deviates more than this amount above the
profile setpoint.
The profile will hold if a PV deviates more than this amount below the
profile setpoint.
900 Control Station User Guide
Setpoint Programmers
Description
View/Edit profile
129