Honeywell 900 User Manual page 147

Item
Elapsed Time
Time Remaining
Recycles Remaining
Operation Buttons
Run
Hold
Advance
Reset
PVs and SPs
SP1 through SP8
PV1 through PV8
Revision 9
May 2014
Time elapsed in the segment. Run time only.
Time remaining in the segment.
Number of recycles remaining, according to the highest numbered
segment so far encountered in the schedule.
Example:
Segment #30 has recycle count = 10 and recycle segment #5. Therefore,
the first time the schedule reaches Segment #30, the schedule will recycle
(repeat) Segments #5 through #30 ten times. During the first recycling, it
will display "10", during the second recycling it will display "9", etc.
Start a schedule that is in HOLD or READY state.
Put schedule in HOLD.
Jump to the next segment.
When the schedule is already in the last segment, the advance request is
ignored.
Schedules cannot be advanced to the first segment. Current state must
either READY or HOLD.
Reset a HOLD or STOP schedule to the first segment. Any edits made to
the schedule are lost unless they were saved. See Save To Schedule List.
Value of all setpoints
Value of all PVs.
900 Control Station User Guide
Setpoint Scheduler
Setpoint Scheduler Operate
Description
135