Interlogix Simon XT User Manual page 39

7. Press STATUS repeatedly to exit.
Sensor lights
In this menu, each sensor can be tied to a unit number. For example, a light in a
room can be set up to turn on when a motion sensor in that room is tripped.
To set up Sensor lights, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Light control, then press Enter.
3. Scroll up/down to Light schedules, then press Enter.
4. Scroll up/down to the desired light schedule (as defined by the unit number),
then press Enter.
5. The current option value now flashes.
6. Enter the desired start time by entering the hours, minutes, and AM/PM
(press Enter after programming each part).
7. Enter the desired end time by entering the hours, minutes, and AM/PM (press
Enter after programming each part).
8. Press STATUS repeatedly to exit.
Light schedules
In this menu, a light schedule can be programmed for each unit number (1 to 8).
To program Light schedules, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Light control, then press Enter.
3. Scroll up/down to Light schedules, then press Enter.
4. Scroll up/down to the desired light schedule (as defined by the unit number),
then press Enter.
5. The current option value now flashes.
6. Enter the desired start time by entering the hours, minutes, and AM/PM
(press Enter after programming each part).
7. Enter the desired end time by entering the hours, minutes, and AM/PM (press
Enter after programming each part).
8. Press STATUS repeatedly to exit.
Housecode
To change the Housecode, do the following:
1. Enter the System programming menu.
Simon XT User Manual 33