Installation - Alpine DVE-5300 Owner's Manual

Installation

Check accessory parts.
HDMI-extension Remote Control Eye Remote Control
Cable (1.5 m)
x 1
Power Cable
HDMI Hold-down
Bracket
x 1
Velcro fastener Flat head screw
(M5 × 8)
x 2
Angle of installation
Install at an angle between horizontal and 30°. Note that installing
at an angle outside of this range will result in a loss of performance
and possibly damage.
0 - 30°
Do not mount the unit in a location of extreme temperature
fluctuations (such as near an air conditioner or heater vent). Disc
read failures or other problems may result.
If mounted in such location, failures such as "Disc can not read." or
other failure may occur.
30
-EN
x 1
x 1
HDMI Hold-down
screw
x 1 x 1
x 4
Installation example using the Original
Mounting Bracket
1
Mount the original mounting bracket to the unit
using the supplied screws (
Ground Lead*
Chassis
Original Mounting Bracket
Screws (M5 × 8) (included)
2
Connect all other leads of the unit according to
details described in the "Connections" (page 33).
3
Mounting the unit in a car.
* To securely connect the ground lead, use an already installed screw
on a metal part of the vehicle (marked (
spot on the vehicle's chassis.
• Fix the cables carefully. Do not damage them by tucking them into
movable parts, such as a seat rail, or by locating them against sharp
or pointed edges.
).
)) or a clean, bare metal