Installation - Siemens 6SE2101–1AA01 Operating Manual

3. INSTALLATION

WARNING
High voltages are generated within this equipment. It must only be installed and operated by
qualified personnel who are familiar with the equipment, its operating requirements and
instructions.
The User is responsible for installation of the motor, drive controller, transformer and other
devices in accordance with regulations and local safety codes which may apply.
Adequate protective clothing (e.g. safety gloves, goggles, etc.) should be worn by the person
installing this equipment.
Failure to observe the appropriate warnings and regulations may result in serious injury or
death.
The inverter must be installed in a vertical position and fixed to a solid surface via its four mounting holes. It is
suitable for wall–mounting or installation within a cubicle.
CAUTION
All inverter variants are air–cooled. Ensure that a free space of at least 100 mm (4 in.) is left both
above and below the unit to allow an unimpeded air flow.
Avoid subjecting the inverter to excessive shock and vibration.
Installation drawings for the inverters are shown on the next page.
3/1 English