Installing The Ink Cartridges; Selecting The Ink Mode - Roland LEC-300 Supplemental Manual

Installing the Ink Cartridges

Models : LEC-300/300A/330/540, LEJ-640
Articles in the Setup Guide * Pages in the First Step Guide for the LEF-12
Replace the information on the following articles of the table of contents with the information found in this document .
LEC-300
LEC-300A
LEC-330

"Installing the Ink Cartridges"

LEC-540
LEJ-640
"STEP 5: Switch On/Make the initial settings"
LEF-12
"STEP 6: Installing the Ink Cartridges"

Selecting the Ink Mode

When you use the printer for the first time, you need to select a proper combination (ink mode) according to the usage .
In the case of LEF-12, this operation is not required . Go on to "Installing the Ink Cartridges" (p . 8) .
Ink mode
Gloss mode
White mode
Gloss/White mode
EUVS ink mode
Procedure
1.
Close the front cover .
2.
If the main power switch is on, then switch it off .
3.
Select the ink mode with the procedure given below .
<Gloss mode>
3-1 .
Hold down
3-2 .
When the message shown below appears on the display screen, release the operation-panel buttons .
SET INK MODE
GLOSS INK
4
1. Changes to the Setup Guide
Ink cartridges
1 cartridge each of cyan, magenta, yellow, and black
2 cartridges of gloss
1 cartridge each of cyan, magenta, yellow, and black
2 cartridges of white
1 cartridge each of cyan, magenta, yellow, black, gloss, and white
1 cartridge each of cyan, magenta, yellow, and black
2 cartridges of white
and , switch on the main power switch .
Ink cartridge type
The EUV ink or EUV3 ink
The EUVS ink