Canon i-SENSYS MF229dw Service Manual page 280

■ MISC-P
● OUTPUT
When outputting the report, place paper in the Pickup Cassette, and remove paper from the
Multi-purpose Tray.
If paper is placed in the Multi-purpose Tray, the report is not output even if paper is placed in
the Pickup Cassette.
COPIER > FUNCTION > MISC-P
Sub item Description
SRVC-DAT To output the system data list/ system dump list as follows;
SYS-DAT To output the system data list.
Service software switches and parameters used in FAX
function are mainly outputted.
SYS-DMP To output the system dump list.
Service data such as the number of communications, the
number of receiving pages and sending pages, and the
number of error are outputted.
CNTR To output the counter report.
Counter values of use trend for reading, storage,
communications, and copy are displayed.
SPEC To output the spec report.
Current device status is printed out.
KEY-HIST Output of the key log report
To output the key log up to the time the transmission task was
input (the [START] key was pressed).
■ SYSTEM
COPIER > FUNCTION > SYSTEM
Sub item Description
DOWNLOAD To switch to the download mode.
8
Service Mode > COPIER > FUNCTION > PARAM
FAX Other
model
Yes No
Yes No
Yes No
Yes Yes
Yes Yes
Yes No
T-8-12
Common to all
models
Yes
T-8-13
8 Service Mode > COPIER > FUNCTION > PARAM
■ PARAM
COPIER > FUNCTION > PARAM
Sub item Description
EXC-NAVI To switch of installation navigation.
Setting value
• 0: Enable (Default)
• 1: Disable
Set this switch to 1 after the termination of installation
navigation.
Installation navigation is not executed when this switch is 1 at
next start-up.
When this service mode is executed, a message
"REBOOTING..." is displayed on the Control Panel, and the
host machine is automatically restarted.
8-7
FAX Other
model
Yes
No
T-8-14
8-7