Test; What Can Go Wrong - ZyXEL Communications ZyWALL 110 Handbook & Instructions

Test

1. Connect a computer to the ZyWALL's LAN interface.
2. Enable IPv6 support on you computer.
In Windows XP, you need to use the IPv6 install command in a Command
Prompt.
In Windows 7, IPv6 is supported by default. You can enable IPv6 in the Control
Panel > Network and Sharing Center > Local Area Connection screen.
3. Your computer should get an IPv6 IP address (starting with 2001:b050:2d:1111: for
this example) from the ZyWALL.
Figure 354
4. Open a web browser and type http://www.kame.net. If your IPv6 settings are
correct, you can see a dancing turtle in the website.

What Can Go Wrong?

1. If you forgot to enable Auto-Configuration on the WAN1 IPv6 interface, you will not
have any default route to forward the LAN's IPv6 packets.
2. To use prefix delegation, you must set the WAN interface to a DHCPv6 client,
enable router advertisements on the LAN interface as well as configure the
Advertised Prefix from DHCPv6 Prefix Delegation table.
www.zyxel.com
238/255