Compliance Statements For Nebs; Compliance Statements For Emc Requirements - Juniper ACX4000 Quick Start Manual

Compliance Statements for NEBS

Compliance Statements for EMC Requirements

Copyright © 2015, Juniper Networks, Inc.
When removing or installing an electrical component, always place it component-side
up on a flat antistatic surface or in an electrostatic bag.
When you install the router, always make the ground connection first and disconnect
it last.
Wire the DC power supply using the appropriate lugs. Always connect the ground wire
first and disconnect it last.
Do not work on the system or connect or disconnect cables during electrical storms.
Before working on equipment that is connected to power lines, remove jewelry, including
rings, necklaces, and watches. Metal objects heat up when connected to power and
ground and can cause serious burns or become welded to the terminals.
Failure to observe these safety warnings can result in serious physical injury.
AC power cable warning (Japan):
WARNING: The attached power cable is only for this product. Do not use
the cable for another product.
The recommended maximum ambient temperature is to 149° F (65° C). For safe
operation take into consideration the internal temperature within the rack.
Note the hot surface warning label on the top rear of the chassis.
The equipment is suitable for installation as part of the Common Bonding Network
(CBN).
The equipment is suitable for installation in locations where the National Electrical
Code (NEC) applies.
The battery return connection is to be treated as an isolated DC return (i.e. DC-I), as
defined in GR-1089-CORE.
For Juniper systems with AC power supplies, an external surge protective device (SPD)
must be used at the AC power source.
Canada on page 22
European Community on page 22
Compliance Statements for NEBS
21