Canon CLC5100 Series Manual page 205

Table of Contents

Advertisement

Sub item
REG NEXT
Use it to delay the timing at which the first sheet of paper is picked up to
prevent lines in main scanning direction near 188 mm from the leading
edge of paper.
Settings: 0 to 1 Standard: 0
0: Normal 1: All environment ON
Remarks:The potential on the transfer belt is not stable when the first
copy is made, with the photosensitive drum at times developing paper
traces (drum memory) caused by the leading edge of paper. The traces
will collect toner, and a line will occur on the next copy near 188 mm
from its leading edge.
CPM DWN
When'cpm down for low temperature'is selected, the plain paper cpm for
the cassette/deck will be made the same as the cpm of the multifeeder
(i.e., increase the sheet to sheet distance) if the environment temperature
sensor (under cassette) registers a reading of 21?C or lower. if A4, 35
cpm; if B4, 22 cpm; if A3, 18 cpm, if extra length, 18 cpm
Settings: 0 to 1
Record any new values on the service data sheet
RT TM PP
A change has been made so that the time length of drum idle rotation may
be changed after auto registration.
Settings range: 0 to 3
0: 15SEC 1: 30SEC 2: 60SEC 3: 120SEC
Record any new values on the service data sheet
VCNT
A mode item has been added so that a specific original density may be
TMG
selected by disabling counting of copies for idle rotation of the drum
when printing at a density higher than a specific level.
Settings range: 0 to 5 Standard: 3
0: count copies for idle rotation regardless of video count (image volume)
1: count copies if image volume is 1.09% or less in relation to paper (may
be single color)
2: count copies if image volume is 1.96% or less in relation to paper (may
be single color)
3: count copies if image volume is 3.92% or less in relation to paper (may
be single color)
4: count copies if image volume is 6.10% or less in relation to paper (may
be single color)
5: count copies if image volume is 8.06% in relation to paper (may be
signal color)
Record any new values on the service data sheet
OPTION > P OPT
Description
Standard: 0
Standard: 2
Chapter 5
5-75

Advertisement

Table of Contents
loading

Table of Contents