Table of Contents
Advertisement
Chapter 5
Sub item
M
RECOVR
OHP
MODE
SMP NUM
THIN APS
5-70
OPTION > R OPT
Use it to execute recovery without moving the scanner for recovery
copying after the presence of a jam or the absence of toner/oil/paper has
been identified.
Settings: 0 to 1
Standard: 0
0: normal operation
1: no re scanning during recovery copying
Conditions: RDF not used, page separation not used, auto vertical/
horizontal rotation not used, double sided copying not used, enlargement
page separation not used, reduced image page composition not used.
Record any new values on the service data sheet.
Select the maximum density when making a copy outo a transparencies.
Settings range: 0 to 2
Standard: 0
If the value is increased, the density becomes darker.
Reference: The projector for OHP has a reflection type and translucent
type. It is preferable to lower the maximum copy density value in the case
of the translucent type projector; therefore, change the maximum copy
density setting according to a projector at user's site.
Use it to change the range of sampling of the data representing the color
selected on an original for color conversion.
Settings: 0 to 1 Standard: 0
0: sample selected color in area of 2x2 (standard)
1: sample selected color in area of 4x4
Record any new values on the service data sheet.
Reference: In the case of an original composed of dots, correct color
identification may not be identified; if such is the case, set it to '1' to
increase the number of samplings.
Use it to enable auto paper selection for thin paper.
Settings: 0 to 1 Standard: 0
0: disable auto paper selection
1: enable auto paper selection
Record any new values on the service data sheet.
Reference: Thin paper will not be selected if of the following modes is
selected:
sort, group, staple
double sided
Description
Advertisement
Table of Contents
