Begin Assembly - Precor Experience Series 700 Line Assembly Manual

Begin Assembly

WARNING DO NOT attempt to connect electrical power until all assembly procedures are complete and console is properly installed.
Important Before unpacking the treadmill, follow the ramp assembly instructions
(included in the box) to build and use a custom ramp to safely and securely roll the
treadmill base off the shipping pallet.
To attach the uprights to the treadmill:
1. Remove the hood from the treadmill base and set it aside.
2. Position a base side cover against the treadmill frame so that the tabs fit into the
frame.
3. Using a #3 Phillips head screwdriver, attach the base side cover using
one screw for the side attachment and one screw
attachment.
Figure 1
for the front
Figure 2
4. Position the right upright support near the base frame and route the data cable
inside of the base side cover and up through the right upright.
Important DO NOT pinch or crush the cable during assembly.
5. Position the right upright support onto the base frame so that the support lip fits
inside the frame and attach it using three screws
Partially tighten.
6. Repeat Steps 3 through 5 to attach the left upright support.
Note Route PVS and console cables up the left upright support. Be careful not
to pinch the cables.
Figure 3
and three washers
Figure 4
.
5