Precor Experience Series 700 Line Assembly Manual page 6

Hide thumbs Also See for Experience Series 700 Line:

Table of Contents

Enlarged version

To attach the dash:

With assistance, set the dash assembly on top of the upright supports.

Note The dash slips down into the uprights. Pull it up slightly so that the screw

holes line up correctly.

Attach the dash assembly to each upright using three screws

washers

. Partially tighten.

Fully tighten all 12 screws to 25 ft-lb. Tighten the lower upright screws in the

order shown in Figure 6.

and three

Figure 5

Figure 6

To complete the dash assembly:

Remove the two screws from the back of the dash cover. Remove the dash cover

and set it aside with the screws.

Route the data cable through the right tube of the dash assembly, up the back

frame, and out through the top hole.

Note If you are attaching a PVS or networked console, route those cables

through the left side of the dash assembly at this time.

Figure 7

Table of Contents