Precor Experience Series 700 Line Assembly Manual page 13

Check the alignment of the running belt
1. Turn on the treadmill.
2. Standing beside the treadmill (not on it), press GO or Quick Start on the
console.
3. Press SPEED UP until the console shows a speed of 3 MPH (5 KPH).
4. Observe the belt from the rear of the treadmill for a few minutes. The belt
should remain centered along the running bed. If it drifts off center, adjust it
(refer to Adjusting the Running Belt section).
Important Failure to align the belt may cause the belt to tear or fray, which is not
covered by the Precor Limited Warranty.
5. Press STOP to stop the belt.
6. Turn off the treadmill.
Test safety features
Important Before any exerciser uses the treadmill, verify that the STOP button, reset
switch, and Auto Stop ™ feature are all working correctly.
To test the Stop button:
1. Start any workout on the treadmill.
2. Press STOP once. The console indicates that the workout is paused.
3. Press STOP again. The console displays a workout summary.
To test the reset switch:
4. Start any workout on the treadmill.
5. Give the safety clip lanyard a slight tug. The reset switch pops up and the
treadmill should slow to a stop immediately.
6. Press the reset switch back into its normal position. The console should reset
itself and return to the Welcome screen or banner.
13