Oki ES9455 Management Manual page 59

2.SETTING ITEMS (ADMIN)
Setting the Sleep or Super Sleep mode
1
On the POWER SAVE screen, press [SLEEP/SUPER SLEEP].
The SLEEP/SUPER SLEEP screen is displayed.
2
Specify the following items as required and complete the setting.
Item name
SLEEP TIMER
SUPER SLEEP
The equipment may not enter the Sleep/Super Sleep mode at the set timing depending on its operating
status.
This equipment does not enter the Super Sleep mode even if [ENABLE] is selected for this setting in the
following cases:
- A particular option is installed. (Wireless LAN module, OKI IC Card Reader)
- The IPsec function is enabled.
- IEEE 802.1X authentication is enabled.
- IPv6 is enabled and the IPv6 address is set other than manually.
- POP3 client setting is enabled and under any of the following conditions:
- A particular network protocol is enabled. (AppleTalk, IPX/SPX)
When the equipment is under the above conditions, [ENABLE] or [DISABLE] of [SUPER SLEEP] cannot be
changed.
Protocol settings for recovering this equipment from the Super Sleep mode are made in the TopAccess
administrator mode. For details, refer to the TopAccess Guide "Chapter 8: [Administration] Tab Page".
Press the desired period of time (in minutes) that this equipment should wait before the
Sleep or Super Sleep mode is activated.
Select whether this equipment enters the Sleep mode or the Super Sleep mode when a
specified period of time has passed.
ENABLE — Press this button to make the equipment enter the Super Sleep mode.
DISABLE — Press this button to make the equipment enter the Sleep mode.
(1) The scan rate is set to other than 0 minute.
(2) A POP3 server address is entered.
(3) An account name is entered.
2 SETTING ITEMS (ADMIN)
Description
GENERAL 57