Calibrating Table Tilt Scale Pointer; Qty - Grizzly G0817 Owner's Manual

To adjust lower wheel shaft position:
1. DISCONNECT MACHINE FROM POWER!
2. Loosen jam nuts on lower wheel adjustment
hub (see Figure 111).
Top Tilt
Adjustment
Hub
Side
Tilt
Bottom Tilt
Figure 111. Lower wheel adjustment controls.
3. Loosen one tilt adjustment set screw, then
tighten opposing set screw approximately an
equal amount.
4.
Check wheels with coplanarity gauge, and
repeat Step 3 as needed until lower wheel is
parallel and coplanar with upper wheel.
5.
Tighten jam nuts to lock tilt adjustment set
screws in position.
6.
Perform previous
Alignment procedure, beginning on Page
66, and adjust wheels as necessary to make
them parallel and coplanar.
7.
When wheels are parallel and coplanar,
remove blade, re-install table, and then re-
install blade.
Model G0817 (Mfd. Since 05/16)
Side
Tilt
Checking Wheel
Calibrating Table Tilt
Scale Pointer
The table tilt scale pointer (see Figure 112) was
calibrated at the factory. However, after prolonged
use the pointer may shift, requiring adjustment.
Note: The table tilt scale functions as a basic
guide only. For high-precision cuts, use a protrac-
tor or bevel gauge to set the angle of table tilt.
Figure 112. Location of table tilt scale and
pointer.
Tools Needed
Machinist's Square ............................................ 1
Phillips Screwdriver #2 ...................................... 1
To calibrate table tilt scale pointer:
1. DISCONNECT MACHINE FROM POWER!
2. Place one edge of square on table and other
edge of square against blade side, as shown
in Figure 113.
Figure 113. Adjusting table perpendicular to
blade (side to side).
Table Tilt
Scale
Pointer

Qty

-69-