Grizzly G0817 Owner's Manual page 56

Guide Post Rack
Lubrication Type ........ GL2 Grease or Equivalent
Amount .................................................Thin Coat
Frequency .......................................... As Needed
To lubricate guide post rack and pinion:
1. DISCONNECT MACHINE FROM POWER!
2. Lower guide post all the way.
3. Use a rag and mineral spirits to wipe off any
grease and sawdust build-up on rack (see
Figure 87).
Guide Post
Rack
Figure 87. Guide post rack exposed for
lubrication.
4. Apply a thin coat of lubricant to rack.
5.
Move guide post up and down several times
to distribute lubricant, then remove any
excess grease to help reduce potential saw-
dust build-up.
Blade Tension Adjustment Assembly
Lubrication Type ........ GL2 Grease or Equivalent
Amount .................................................Thin Coat
Frequency .......................................... As Needed
To lubricate tension adjustment assembly:
1. DISCONNECT MACHINE FROM POWER!
-54-
2. Open upper wheel cover and look through
top of wheel (see Figure 88).
Look Through Here
Figure 88. Location of blade tension adjustment
assembly.
3.
Use a rag and mineral spirits to wipe off any
grease and sawdust build-up on blade ten-
sion adjustment assembly and tension lever
cam (see Figure 89), then apply thin coat of
lubricant to these areas.
Cam
Figure 89. Lubrication locations for tension
adjustment assembly (wheel removed for clarity).
Trunnions
The cast iron trunnions (see Figure 90) produce a
fine graphite powder over time that acts as a lubri-
cant. We recommend not adding lubricant to the
trunnions, which could make a sticky substance
that would prevent smooth movement.
Sliding Surfaces
Figure 90. Cast iron trunnions produce their own
lubricant.
Model G0817 (Mfd. Since 05/16)
Adjustment
Assembly