Grizzly G0817 Owner's Manual page 60

Operating Machine (Continued)
Symptom Possible Cause
Gullets loaded with 1. Excessive feed rate/pressure.
chips. 2. Blade TPI is too fine.
Backside of blade 1.
deformation/ 2. Blade tension too high.
cracking. 3. Blade support bearing improperly adjusted.
Sawdust buildup 1. Blade brushes under table are worn or mis-
inside cabinet.
2. Clogged dust port.
3. Low CFM (airflow) from dust collection
-58-
Excessive feed rate/pressure.
adjusted.
system.
Possible Solution
1. Reduce feed rate/pressure.
2. Install correct blade (Page 41).
1. Reduce feed rate/pressure.
2. Adjust blade tension (Page 28).
3. Properly adjust blade support bearing (Page 31).
1. Properly adjust brushes; replace if necessary
(Page 62).
2. Clean dust port.
3. Inspect ducting for leaks/clogs and repair as
necessary; move dust collector closer to machine;
install a stronger dust collector.
Model G0817 (Mfd. Since 05/16)