Replacing Brake Shoe; Wrench 13Mm - Grizzly G0817 Owner's Manual

3. Adjust table tilt (refer to Tilting Table, begin-
ning on Page 47 for more information) until
square rests flush and evenly against both
table and blade side.
Note: Make sure square does not go across
a blade tooth when performing this step.
4.
Loosen Phillips head screw that secures
table tilt pointer (see Figure 114), adjust
pointer to "0" on scale, then retighten screw.
Figure 114. Location of screw that secures table
tilt pointer.
Replacing
Brake Shoe
The brake shoe needs to be replaced if one or
more of the following conditions are met:
• If the bandsaw takes noticeably longer to stop
when the foot brake is pushed.
• The foot brake makes metal-to-metal grinding
sounds.
• The thickness of the brake shoe pad mea-
sures 1mm or less.
Components and Hardware Needed:
Replacement Brake Shoe (Part P0817119) ....... 1
Tools Needed:
Hex Wrench 5mm .............................................. 1
Hex Wrench 6mm .............................................. 1
Wrench 10mm ................................................... 1
Wrench 17mm.................................................... 1
-70-
Screw
To replace brake shoe:
1. DISCONNECT MACHINE FROM POWER!
2. Remove lower wheel and V-belt (refer to
Steps 1-6 in Replacing V-Belts on Page 60).
3.
Remove cap screws, lock washers, and bush-
ings that secure brake shoe to brake lever,
then remove brake shoe (see Figure 115).
Cap Screws
Brake Shoe
Figure 115. Lower wheel removed to expose
brake shoe components.
4. Install new brake shoe using cap screws, lock
washers, and bushings removed in Step 3.
5. Re-install V-belt and lower wheel.
6. Tension V-belt
Replacing V-belt on Page 59).
7.
Re-install, tension, and track blade, then
adjust upper and lower blade guides and sup-
port bearings as needed (refer to Changing
Blade on Page 46).
8.
Close wheel covers.
Model G0817 (Mfd. Since 05/16)
Brake Lever
(refer to Tensioning/