Replacing A Power Supply - HP ProLiant DL360 G9 Maintaining And Troubleshooting

Hide thumbs Also See for ProLiant DL360 G9:

Raid configuration (11 pages)

Table Of Contents

Table of Contents

Maintaining and Troubleshooting the HP ProLiant DL360 G9 Server

System Power

Definition

LED

Flashing Green

System is waiting to power on; Power On/Standby button is pressed.

Solid Green

System is powered on.

Procedure

1. To troubleshoot possible power source problems:

a. Plug another device into the grounded power outlet to be sure the outlet works. Also, be

sure the power source meets applicable standards.

b. Replace the power cord with a known functional power cord to be sure it is not faulty.

c. Replace the power strip with a known functional power strip to be sure it is not faulty.

d. Have a qualified electrician check the line voltage to be sure it meets the required

specifications.

e. Ensure the proper circuit breaker is in the On position.

If power source is not the problem, continue with steps below to troubleshoot power

supplies.

2. Ensure no loose connections exist.

3. Press the Power On/Standby button to be sure it is on. If the server has a Power On/

Standby button that returns to its original position after being pressed, be sure you press the

switch firmly. For more information about system power LED status, see

HP ProLiant DL360 G9 Server

4. Check the power supply LEDs, ensure they indicate that each power supply is working

properly. If the LEDs indicate a problem with a power supply (red, amber, or off), then check

the power source. If the power source is working properly, then replace the power supply.

5. If running a redundant configuration, be sure that all of the power supplies in the system

have the same spare part number and are supported by the server.

6. If power supplies are redundant and server is powered up, see

using HP ProLiant DL360 G9 Server console

Supplies and view power supply health.

Next steps

If the part is defective, continue with the following removal and replacement procedures.