Open Shortest Path First - Avaya 8800 Configuration Manual

Ethernet routing switch
Table of Contents

Advertisement

routes should be learned. For example, to redistribute OSPF routes to RIP, apply the following
route policy to a RIP-enabled interface:
config ip route-policy rip_pol seq 1 create
config ip route-policy rip_pol seq 1 enable
config ip route-policy rip_pol seq 1 action permit
config ip route-policy rip_pol seq 1 match-protocol ospf
You can redistribute routes on a global basis, rather than on a per-interface basis. Release 5.0
adds support for global RIP redistribution. Use the config ip rip redistribute
command to accomplish the (intraVRF) redistribution of routes through RIP, so that RIP
redistribution occurs globally on all RIP-enabled interfaces. This redistribution does not require
a route policy, but one can be used for more control.
If you configure redistribution globally and on an interface, redistribution through the route
policy takes precedence. If a route policy is defined for an interface, it is enforced.
You can redistribute routes from a protocol in one VRF to RIP in another VRF using the config
ip <dst-vrf> rip redistribute <source-protocol> <context> [vrf-src
<vrf-name>] commands. You can use a route policy for redistribution control. If you enable
route redistribution between VRF instances, ensure that IP addresses do not overlap.
Table 4: RIP redistribution configuration procedures
For information about:
Using Enterprise Device Manager to
configure interVRF route
redistribution
Using the CLI to configure interVRF
RIP route distribution
Using the ACLI to configure interVRF
RIP route distribution
Using Enterprise Device Manager to
configure RIP route redistribution
Using the CLI to configure RIP route
redistribution
Using the ACLI to configure RIP route
redistribution

Open Shortest Path First

Open Shortest Path First (OSPF) is an Interior Gateway Protocol (IGP) that distributes routing
information between routers belonging to a single autonomous system (AS). Intended for use
Configuration — OSPF and RIP
See:
Avaya Ethernet Routing Switch 8800/8600
Configuration — IP Routing, NN46205-523
Configuring interVRF route redistribution for RIP
page 93
Configuring interVRF route redistribution for RIP
page 108
Configuring route redistribution to RIP
page 70
Configuring route redistribution to RIP
page 90
Configuring route redistribution to RIP
page 106
Open Shortest Path First
on
on
on
on
on
June 2011
33

Advertisement

Table of Contents
loading

This manual is also suitable for:

8600

Table of Contents