Changing The Bulb - Rangemaster RMB608BL User Manual

Fig. 7.4
Fig. 7.5
ArtNo.324-0005 Oven light bulb
Removing the glass from the door
1. Follow the procedure to remove the door.
2.
Place the door on a soft and clean surface. With both
hands hold the door and push the buttons on either
side of the oven door (Fig. 7.4).
3.
One the top cap has been removed you will have access
to the glass. Flip the glass retainers and gently remove
the glass.
4. Clean the glass with soap and water and place on a
clean, dry and soft surface.
5.
Reassemble the door in the reverse order.
Refitting the Oven Door
To refit the door, slide the hinges back into their slots. Rotate
the locking 'U' clips back to fit onto the hinges.
Oven
DO NOT use steel wool, oven cleaning pads, or any

other materials that will scratch the surface.

Changing the bulb

Back light
Fig. 7.5
You can buy a replacement bulb (which is not covered
under the warranty) from a good electrical shop. Ask
for a 15 W – 230 V lamp, FOR OVENS. It must be a special
bulb, heat resistant to 300 °C.
●
Turn off the power at the circuit breaker.
●
Before removing the existing bulb, turn off the power
supply and make sure that the oven is cool. Open the
oven door and remove the oven shelves.
●
Unscrew the protective cover by turning counter-
clockwise. It may be very stiff. We recommend that you
wash and dry the glass cover at this point.
●
Carefully unscrew the old bulb and insert the new bulb.
●
Screw back the bulb cover. Turn on the circuit breaker
and check that the bulb now lights. Refit the protective
cover.
IMPORTANT
Never use screwdrivers or other utensils to remove

the light cover. This could damage the enamel of the
oven or the lamp holder.
Remove only by hand.

Never replace the bulb with bare hands as

contamination from your fingers can cause
premature failure. Always use a clean cloth or
gloves.
Please note: The bulb replacement is not covered by

your guarantee.
10