Oven; Steam Assisted Cleaning; Changing The Bulb - Rangemaster RMB6013BL/SS User Manual & Installation & Service Instructions

13 function single oven
Table of Contents

Advertisement

Fig. 6.4
Fig. 6.5
Fig. 6.6
ArtNo.324-0005 Oven light bulb
Fig. 6.7
Removing the glass from the door
Open the oven door so you are able to access the screws on
the edge of the oven door (Fig. 6.4).
Remove the 2 screws (Fig. 6.4).
Remove the plate from the top od the oven door (Fig. 6.5).
Carefully remove the inner galss from the door and place ona
soft, flat surface.
Clean the glass with soap and water and dry with a soft cloth.
Reassemble the door in the reverse order.

Oven

DO NOT use steel wool, oven cleaning pads, or any
n
other materials that will scratch the surface.

Steam assisted cleaning

This function assists in the removal of food residue from
inside the oven.
This method is effective in removing light soiling only. It is not
effective in removing stubborn baked-on stains.
Note: It can only be used when the oven is cold.
1.
Remove all shelves, dishes and side racks.
2.
Make a solution of water (85%), white vinegar (10%) and
dish washing detergent (5%) and spray liberally on to the
door, side walls and back wall of oven cavity (Fig. 6.6).
3.
Pour 40ml of water into the cavity base well.
4.
Close the door. Set the function to Steam Assist Clean
and set the temperature to 130°C.
5.
Turn oven OFF after 18 minutes.
6.
Allow to cool to a safe level before wiping surface with a
wet cloth.

Changing the bulb

You can buy a replacement bulb (which is not covered under
the warranty) from a good electrical shop. Ask for a 15 W
– 230 V lamp, FOR OVENS. It must be a special bulb, heat
resistant to 300 °C (Fig. 6.5).
Turn off the power at the circuit breaker.
n
Before removing the existing bulb, turn off the power supply
and make sure that the oven is cool. Open the oven door and
remove the oven shelves.
Unscrew the protective cover by turning counter-clockwise. It
may be very stiff. We recommend that you wash and dry the
glass cover at this point.
Carefully unscrew the old bulb and insert the new bulb.
Screw back the bulb cover. Turn on the circuit breaker and
check that the bulb now lights. Refit the protective cover.
18

Advertisement

Table of Contents
loading

Table of Contents