McIntosh C200 Owner's Manual page 23

Mono
Setup
Mute
Output 1 and 2
Reset of Microprocessors
Note: The above condition is usually caused by either
interruptions in AC power and/or major changes in
voltage.
How To Make A Tape Recording
Figure 25
2.
Note: The C200 RECORD OUTPUTS are not affected by
the VOLUME or BALANCE controls. To listen to a
different program source while recording, turn the
LISTEN switch to the desired source. The recording
process will not be affected and will continue.
How to use a Signal Processor
How to use the Passthru Mode
How to Operate the C200
Figure 26
23