Input Trim Level
Note: The possible range of adjustment in volume level is ±
12dB. The Record Output Levels are uneffected by any
changes in the Trim Settings. Any TRIM adjustments
made are retained in permanent memory and can be
changed only by performing a new TRIM procedure.
Note: Choose a Input Source that is frequently listened to
as the reference. The reference Input Source should
be set to a Trim Level of 00.
Note: Whenever a program source selected has trimmed
volume levels, the Front Panel Display Volume
Figure 9
Figure 10
Figure 11
Indication will automatically move up or down
when changing between Input Sources to reflect the
differences in trim levels. The Trim Level can also
be set via the remote control. The following table
may be used to record your level trim adjustments
for the various inputs.
DÃT
pr
9rshyÃTrvt
Ur
UhrÃ
Uhrà !
GvrÃ
Gvrà !
QuÃ
à à 6Ã
QuÃ!Ã Ã 6Ã!
Input Selection
Note: If all the Input Sources have been turned Off and the
C200 is no longer in the Setup Mode, the Front Panel
Display will Indicate NO SOURCE. Two Input Positions
on the C200 have a Rear Panel Slide Switch associated
with them. This allows selection of three additional
component sources to be connected, however only eight
possible Input Sources can be selected from at any one
time.
IrÃTrv t
Figure 12
Setup
19