McIntosh C200 Owner's Manual page 11

MAIN Balanced
OUTPUTS contain
Listen program
signals at all times
SPKR/AMP 1 and 2
Balanced OUTPUTS
contain Listen signals
and turn On/Off with
the front panel OUT-
PUTS 1 and 2 push-
buttons
TO C200C CONTROLLER
connector accepts a 25 con-
ductor cable that connects
all control signals and power
supply voltages from the
C200C to the C200P
LISTEN MAIN unbalanced
OUTPUTS contain Listen
program signals at all times
LISTEN unbalanced OUT-
PUTS 1 and 2 contain Listen
signals and turn on/off with the
front panel SPKR/AMP push-
buttons
RECORD PROCESSOR
FROM and TO allows an
external signal processor to
be connected for use in the
Record mode
TAPE 1 Balanced
OUTPUTS contain
Record Out Signals
TAPE 1, TAPE 2
unbalanced OUT-
PUTS contain
record out signals
LISTEN PROCESSOR
FROM and TO allows an
external signal processor to
be connected for use in the
Listen mode
C200P Rear Panel Switches and Connections
AUX 1 accepts high level program
source signals. PH 1 (MC) accepts low
level signals from a Moving Coil Phono
Cartridge and PH 1 (MM) accepts sig-
nals from a Moving Magnet Phono Car-
tridge. The small slide switch selects
which one of these three inputs is active
when either front panel LISTEN or
RECORD switch is set to PHX/AUX 1
LINE 1, LINE 2 and TAPE 1
Balanced INPUTS accept high
level program source signals
AUX 2 accepts high level program
source signals. PH 2 (MM) accepts
signals from a Moving Magnet Phono
Cartridge. The small slide switch se-
lects which one of these inputs is ac-
tive when the front panel LISTEN or
RECORD Selector switch is set to PH/
AUX 2
TAPE 2, Tuner, and CD un-
balanced INPUTS accept high
level program source signals
Gound connection
for turntables
11