3.5.2.3 Front-end/PA Control Interface
Two outputs (FE1, FE2) for direct control of antenna switch modules enable to select RX- and TX-mode as well
as low- and high-band operation.
An extra band select signal PABS for the power amplifier is used, to support discrete PA and switching
modules. Time accurate power dissipation of the PA is achieved by the control signal PAEN.
A minor set of power amplifiers require a bias voltage to enhance power efficiency. Support of this power
amplifiers is achieved by the implemented bias DAC.
LGE Internal Use Only
LGE Internal Use Only
Figure. 3.5.4 PA AND FEM CONTROL BLOCK DIAGRAM
- 39 -
- 39 -
Copyright © 011 LG Electronics. Inc. All right reserved.
Copyright © 011 LG Electronics. Inc. All right reserved.
3. TECHNICAL BRIEF
Only for training and service purposes
Only for training and service purposes