HP 7475a Operation And Interconnection Manual page 70

2. Set the switches on the rear panel of your plotter as shown in the
following diagram. Your plotter checks the switch settings only
when you turn it on, so
changing the switch settings.
-
�
" "
PARITY
---,-
· 0 ·
seT 5 1 TO FOR
NO PARITY. SETTING
OF 52 IS IRRELEVANT.
Turn on the plotter and boot up the Amiga using your working
3.
copy of the Workbench operation system.
Run the Printer utility in the Workbench Preferences drawer (refer
4.
to Commodore's Workbench documentation).
5. From the Printer main menu, select the
Save your settings and return to the Preferences drawer.
6.
7. Set the Amiga's serial port settings as follows (refer to Comm<>­
dore's Workbench documentation).
a. Double click on the Serial icon in the Preferences drawer.
b. Select the following settings.
Baud Rate:
Read Bits:
Stop Bits:
Handshaking:
Buffer Size:
Write Bits:
Parity:
c. Save your settings and return to the Workbench.
3-18 PLO'ITER INTERCONNECJ'JON
be
sure the plotter is turned off before
SET TO US POSITION FOR A AND B
PAPER OR TO MET FOR A4 AND A3 PAPER.
SET TO A4 FOR A AND A4 PAPER
OR TO A3 FOR 8 AND A3 PAPER.
)- � � iD m ; iI)
o
SET 84 AND 82 TO
8 1 TO
seT TO POSITION
OPERATING ENVIRONMENT.
9600
8
1
RTS/Cl'S
512 (may be adjusted as needed)
8
None
" 1
AND 83 AND
�
· 0 ·
9600
FOR BAUD RATE.
" 0 "
FOR ENDLlNE
interface.
Serial