Set Switch - Alfa Romeo Giulia 2017 Owner's Manual

Setting a speed activates the system.
The display shows the icon in green
with the set speed.
Warning!
Leaving the Adaptive Cruise Control (ACC)
system on when not in use is dangerous.
You could accidentally set the system or
cause it to go faster than you want. You
could lose control and have a collision.
Always leave the system off when you are
not using it.
Pausing/Deactivating
With the feature enabled (speed not
set), push the
disable.
With the feature active (speed set),
push the (on/off) button to pause.
The display will show the icon in white
with the speed in brackets. To then
deactivate the feature, push the
(on/off) button again.
Setting The Desired
Speed
The speed can be set from a minimum
of 20 mph (30 km/h) to a maximum of
110 mph (180 km/h).
When the vehicle reaches the desired
speed, push the SET switch upward or
downward and release it to activate the
system. When the accelerator is
160
released, the vehicle will maintain the
set speed automatically.
While the accelerator pedal is pressed,
the system will not be able to control
the distance between the vehicle and
(on/off) button to
the one ahead. In this case, the speed
will be determined only by the position
of the accelerator pedal.
The system will return to normal
operation as soon as the accelerator
pedal is released.
The system cannot be set:
been operated.
or NEUTRAL (N) is engaged
maximum threshold.

SET Switch

When pressing the brake pedal.
When the brakes are overheated.
When the electric park brake has
When either PARK (P), REVERSE (R)
When the engine rpm is above a
When the vehicle speed is not within
the operational speed range.
When the ESC (or ABS or other
stability control systems) are operating
or have just operated.
When the ESC system is off.
When the Forward Collision Warning
system (if equipped) is braking
automatically.
In the event of system failure.
When the engine is OFF.
07146S0017EM
In case of obstruction of the radar
sensor (in this case the bumper area
where it is located must be cleaned).
If the system is set, the conditions
described above also cause a
cancellation or deactivation of the
system. These situations may vary
according to the conditions.
Note: The system will not be
deactivated when speeds higher than
those set are reached by pressing the
accelerator pedal above 110 mph
(180 km/h). In these situations, the
system may not work correctly and it is
recommended to deactivate it.