Engine Block Heater; Turbocharger Cool Down; Equipped - Alfa Romeo Giulia 2017 Owner's Manual

Turbocharger Cool
Down
Before switching the engine off, keep it
idling for a few minutes so that the
turbocharger can be suitably lubricated.
This procedure is particularly
recommended after severe driving.
After a full load operation, keep the
engine idling for three to five minutes
before switching it off.
This time allows the lubricating oil and
the engine coolant to eliminate the
excessive heat from combustion
chamber, bearings, inner components
and turbocharger.
140
ENGINE BLOCK
HEATER — IF

EQUIPPED

The engine block heater warms the
engine and permits quicker starts in
cold weather.
Connect the cord to a 110-115 Volt AC
electrical outlet with a grounded,
three-wire extension cord.
For ambient temperatures below 0°F
(-18°C), the engine block heater is
recommended. For ambient
temperatures below -20°F (-29°C), the
engine block heater is required.
The engine block heater cord is routed
under the hood, behind to the driver's
side headlamp. Follow the steps below
to properly use the engine block heater:
1. Locate the engine block heater cord
(access door on the passenger side
wiper cowl).
2. Pull the cord to the front of the
vehicle and plug it into a grounded,
three-wire extension cord.
3. After the vehicle is running, properly
stow away behind access door on the
passenger side wiper cowl.
Note:
The engine block heater cord is a
factory installed option. If your vehicle
is not equipped, heater cords are
available from your authorized dealer.
The engine block heater will require
110 Volts AC and 6.5 Amps to activate
the heater element.
The engine block heater must be
plugged in at least one hour to have an
adequate warming effect on the
engine.
Warning!
Remember to disconnect the engine block
heater cord before driving. Damage to the
110-115 Volt electrical cord could cause
electrocution.