Select Menu Display Language; Setup Network; Use Philips Easylink - Philips BDP9500 User Manual

Select menu display language

Note
•
If this product is connected to a HDMI CEC compliant
TV, skip this setting. It switches automatically to the
same OSD menu language as per your TV setting (if the
language set on TV is supported by this product).
1
In the Home menu, select [Settings] and press
OK.
2
Select [Preference Setup], then press .
3
Select [Menu Language], then press .
Menu Language
Video Setup
Parental Control
Screen Saver
Audio Setup
Change Password
Preference Setup
Display Panel
Auto Standby
EasyLink Setup
VCD PBC
Advanced Setup
• The language options may vary from
different regions.
4
Press to select a language, then press OK.

Setup network

To enjoy software updates of this product and BD-
Live bonus contents for certain Blu-ray discs, set up
the network connection.
Note
•
Ensure that the network cable is properly connected and
the router is switched on.
1
Connect this product to the broadband
modem or router.
2
In the Home menu, select [Settings] and press
OK.
3
Select [Advanced Setup], then press .
4
Select [Network], then press OK.
5
Select [Next] in the menu, then press OK.
»
This product starts to detect if there is a
connection to the network.
»
If the connection test fails, select
and press OK to re-connect again to the
network.
12 EN
6
7
•
•

Use Philips EasyLink

This product supports Philips EasyLink which uses the
HDMI CEC (Consumer Electronics Control) protocol.
You can use one single remote control to control
EasyLink-compliant devices that are connected
through HDMI connectors.
•
One-touch play
1
One-touch standby
1
•
[Retry]
Once connected, an IP address is obtained
automatically.
• If no IP address is obtained, select
[Retry] and press OK to try to obtain
the IP address again.
Select [Finish] in the menu, then press OK to
exit.
Note
This product does not support automatic detection of an
Ethernet crossover cable.
Loading BD-Live content from the internet may take
some time, depending on the file size and the speed of
the internet connection.
Note
To enable the EasyLink feature, you must turn on the HDMI
CEC operations on the TV and on other devices connected
to TV. Refer to the TVs/devices manual for details.
Press the STANDBY
product.
»
The TV (if supports one-touch play)
automatically turns on and switches to the
correct video-in channel.
»
If a disc is loaded in this product, disc play
automatically starts.
Press and hold the STANDBY
more than 3 seconds.
»
All the connected devices (if the device
supports one-touch standby) automatically
switch to standby.
Note
Philips does not guarantee 100% interoperability with all
HDMI CEC devices.
button to turn on this
button for