Preference Setup - Philips BDP9500 User Manual

[Digital Audio]
Select an audio format for the sound output from
the DIGITAL OUT jack (coaxial/optical).
• [Auto] - Detect and select the best supported
audio format automatically.
• [PCM] - The audio device does not support
multi-channel format. Audio is downmixed to
two-channel sound.
• [Bitstream] - Select the original audio to
experience Dolby or DTS audio (BD-video
special sound effect is disabled).
Note
•
Ensure that the audio format is supported by the disc
and the connected audio device (amplifier/receiver).
•
When [Bitstream] is selected, interactive audio like
button sound is muted.
[PCM Downsampling]
Set the sampling rate for PCM audio output from
the DIGITAL OUT jack (coaxial/optical).
• [On] - PCM audio is down-sampled at 48kHz.
• [Off] - For BD or DVD recorded in LPCM
without copyright protection, two-channel
audio signals up to 96 kHz are output as LPCM
signals with no conversion.
[Speaker Setup]
Optimize the surround output for the connected
speaker system.
• [Speaker Setup]
Activate the test tone for the speakers and the
subwoofer.
• [Speaker Distance]
Set the delay time for the speakers and the
subwoofer if they are placed closer to the
listening position, so that the sound output
from all speakers reach the listening position at
the same time.
• [Speaker Volume]
Set the volume level of the speakes and the
subwoofer to get the ideal audio balance.
• [Speaker Size]
• Set the speaker size for the speakers and
the subwoofer.
• Select [Large] size for speakers that can
produce low frequency signal below
120 Hz.
• Select [No Speaker] if there is no
speaker connected.
• If the front speakers are set to
subwoofer setting is [On] and it cannot
be changed.
• If the subwoofer is set to
front speakers settings are [Large] and it
cannot be changed.
[Small],
[Off], the
Tip
•
The test tone is emitted from the speaker while adjusting
the volume level.
•
Allow 1ms setting for every 30cm distance between the
speaker and the listening position.

Preference Setup

1
Press .
2
Select [Settings], then press OK.
3
Select [Preference Setup], then press .
Menu Language
Video Setup
Parental Control
Audio Setup
Screen Saver
Change Password
Preference Setup
Display Panel
Auto Standby
EasyLink Setup
VCD PBC
Advanced Setup
4
Select an option, then press OK.
5
Select a setting, then press OK.
• To return to the previous menu, press
BACK.
• To exit the menu, press
[Menu Language]
Select an on-screen menu language.
Note
•
If this product is connected to an HDMI CEC compliant
TV using a HDMI cable, it switches automatically to the
same menu display language as per your TV setting (if the
language set on TV is supported by this product).
[Parental Control]
Restrict access to discs that are unsuitable for
children. These types of discs must be recorded
with ratings.
To access, enter your last set password or '0000'.
Note
•
Rated discs above the level you set in
require a password to be played.
•
The ratings are country-dependent. To allow all discs to
play, select '8' for DVD-video and BD-Video.
•
Some discs have ratings printed on them but are not
recorded with ratings. This function has no effect on
such discs.
[Screen Saver]
English
Off
Off
Normal
On
On
.
[Parental Control]
EN 19